TOYODA

Upgrade information

PCwin PCwin2(JPN/ENG/CHN)V19.4R02 V2.4R02

Release Date:October,2020

Upgrade Program's

TJA-2032(JPN)
TJA-2051(JPN)L5
TJA-2031(ENG)
TJA-2054(ENG)L5
TJA-6233(CHN)
TJA-6234(CHN)L5

Upgrade information

[ PCwin ]
Bug corrections
・Fixed a problem that the circuit jump operation from the usage status screen may jump to the wrong address in the case of EP, EK, EV, ET, EX, EM devices.
[ PCwin2 ]
Function improvement
・Added support for Nano module for Module block diagram in I/O Drawing function.
・Communication monitor function now supports the linked module "EtherNet/IP+CIP Safety".
・In the link parameter settings of the link modules "EtherNet/IP" and "EtherNet/IP+CIP Safety", even if the connection setting is set to "Do not", detailed settings can be made.
・In the link Parameter setting of the link module "EtherNet/IP" and "EtherNet/IP+CIP Safety", "Address of output area of connection setup" was added to the option setting item.
Target module: Nano 10GX(Ver2.4 or later), Nano 2ET(Ver2.3 or later)
Bug corrections
・Fixed a problem that caused the link Parameter that was originally set to disappear when the cancel operation was executed when the link Parameter of EtherCAT was automatically set from Network Drawing.
・Fixed a problem that prevented SFC step comments from appearing when opening a project file.
・Fixed a problem that the defragment FB execution memory may not be completed normally with the circuit of program 2 or program 3 open.
・Fixed a problem that when the jump destination is outside the FB, the coil jump from the contact in the FB cannot jump to the corresponding coil.
・Fixed a problem that caused Block checking to show a block with no difference as a difference.